SUNGOLDPOWER 15000W Peak 45000W Split Phase Pure Sine Wave Power Inverter,Low Frequency Inverter DC 48V AC Input 240V AC Output 120V 240V Converter, with 80A MPPT Solar Charger Controller 15KW
(as of Apr 16,2023 12:03:24 UTC – Details)
You can disable the inbuilt solar controller, connect with external solar controller, or use for other systems (it is not limited for solar system)
15KW split phase pure sine inverter charger DC 48V AC 240V input AC output 120V/240V*Auto Generator Start (AGS)*Support Solar Panel with MPPT FunctionInclude Battery Temperature Sensor (BTS) and Remote Control8 kinds of battery voltage selection ( lithium LiFePO4, gel, AGM and lead Acid batteries）*Compatible With All kind of Home & Office Appliances*Powerful Charge Rate Up to 120Amp, Selectable From 0%-100%*Built-in transfer switch and battery charge, backup or off grid power solutions*AC/Battery Priority Mode, Designates the Inverter-Preferred UPS Configuration*4-step Intelligent Battery Charging, PFC (Power Factor Correction) for Charger*8 ms Typical Transfer Time Between Utility & Battery,Ensure Power Continuity*15s Delay Before Transfer when AC Recover, Protection for Load when Used with Generator
Output Voltage: Depends on battery typeBattery Initial Voltage for Start Up: 40-62.8VOver Charge Protection Shutdown :62.8VCharger Breaker: 100A Input Voltage Waveform :Sine wave (Grid or Generator) AC input range:184-253Vac/140-270Vac Nominal Input Frequency :50Hz or 60Hz (Auto detect)
Continuous Output Power :15.0KWSurge Rating(20s) :45.0KWOutput Waveform :Pure Sine WaveAC Output Voltage: 120V and 240VAC Input Voltage:240V ( not suitable for AC 120V input )DC Battery Voltage:48VdcSolar charger Current:60AmpAC Battery charger:100±5AmpOutput Frequency :50Hz /60HzTypical transfer Time :10ms(Max)
Solar controller（you can disable our solar controller, and connect with external solar controller） Solar Input Voltage Range: 60-145Vdc Max.PV Open Circuit Array Voltage:145Vdc Rated Charge Current :60A Over Charge Disconnection: 59.2V Over Charge Recovery :54.4V Over Discharge Disconnection:43.2 V(default) Over Discharge Reconnection :49.6V
15KW 48V Split Phase Pure Sine Wave Power InverterEnglish ManualRemote ControlBTS CableUnit Weight: 176.6 lbsUnit Size L x W x H: 28.7 x 16.5 x7.9 inchShipping Weight:210.3 lbsShipping Size L x W x H :33.9 x 21.3 x 15.7
Nominal Input Voltage :48.0VdcMinimum Start Voltage :40.0Vdc / 42.0VdcLow Battery Alarm :42.0Vdc / 44.0VdcLow Battery Trip :40.0Vdc / 42.0VdcHigh Voltage Alarm :64.0VdcLow Battery voltage recover :62.0VdcPower Saver on Idle Consumption: 45WPower Saver off Idle Power: 225W
Battery Charger & LED
Battery type Suitable: lithium LiFePO4, gel, AGM and lead Acid batteries. We recommend checking battery charging specifications for all batteries.
Charging Current Control: The max charge current can be adjusted from 0%-100%
Over load tripOver temperature tripCharger on float/fast charger modeInverter power on line,battery charger offShore power on line battery charger active
Auto Generator Start: The inverter can start up a generator when battery voltage goes low.Generator power should be 1.5 times higher than the inverter power.
Battery Temperature Sensor: BTS cable can monitor the batteries for extended life and longevity.
AC/Battery Priority: The AC Priority and Battery Priority switch is selected by SW5.
Remote Control: Comes with 33 foot connection cable, control the power on/off
AC Wiring Method:
240V split phase:
Input: Hot line+Hot line+Ground
Output 1: Hot line+Hot line+Neutral
Output 2: Hot line+Neutral
1.The output voltage of this unit must never be connected in its input AC terminal
2.Always switch on the inverter before plugging in any appliance.
10000W 6000W 6000W 5000W 4000W 4000W
DC Input Voltage
24V 48V 24V 12V 12V 24V
AC Input Voltage
240V 240V 240V 240V 240V 240V
AC Output Voltage
Split Phase 120V and 240V Split Phase 120V and 240V Split Phase 120V and 240V Split Phase 120V and 240V Split Phase 120V and 240V Split Phase 120V and 240V
*Our inverter is designed with AC priority by default. This means, when AC input is present, the battery will be charged first, and the inverter will transfer the input AC to power the load.The AC Priority and Battery Priority switch is SW5.When you choose battery priority, the inverter will inverting from battery despite the AC input
*LF-PV Series Inverter is equipped with a powerful charger of up to 120Amp (depending on Model).The overload capacity is 300% of continuous output for up to 20 seconds to reliably support tools and equipment longer. the max chargecurrent can be adjusted from 0%-100% via a liner switch at the right of the battery type selector.This will be helpful if you are using our powerful charger on a small capacity battery bank
* Features: Smart Remote Control, Automatic Generator Starting (AGS), Support Solar Panel with MPPT Function. 8 pre Set Battery Type Selector plus De-sulphation for Totally Flat Batteries. 4-step Intelligent Battery Charging, PFC (Power Factor Correction) for Charger. 8 ms Typical Transfer Time Between Utility & Battery, Guarantees Power Continuity. 15s Delay Before Transfer when AC Resumes, Protection for Load when Used with Generator
*Applicantion:for all the kinds of load:circular saws,drills,grinders,sanders,buffers,weed and hedge trimmers, air compressors.computers,printers,monitors,facsimile machines, scanners.vacuum cleaners, fans, fluorescent and incandescent lights,shavers, sewing machines.coffee makers, blenders,ice markers, toasters.metal halide lamp, high– pressure sodium lamp.television, VCRs,video games, stereos,musical instruments, satellite equipment etc